Spectrum S125E

Instructions:

1Press MENU in your remote control

2It will show you the following menus on your screen

Edit Channel

Installation

System Setup

Tools

Game

3Go to INSTALLATION and press OK

4A dialog box may appear, requesting a password. Just put in 8260

5A new set of menus will appear on your screen

Antenna Connection

Satellite List

Antenna Setup

Single Satellite Search

Multi Satellite Search

TP List

6Choose TP List then press OK

7On theTP List menu, press the green button on your remote control to Add a new TP

8On the Add TP box, enter the following parameters:

Frequency	12622.25 MHz
Symbol Rate	14.642860
Polarity	H

9Select SAVE (You should see that the signal strength and quality will reach at least 60%)

10Search for the channel by pressing the blue button on your remote

11On the TP Search box, enter the following:

FTA	Yes
Scan Channel	TV + Radio
Network	Yes

12Press OK. It will now scan for the available channels. Once detected, the channels will be added to your channel list.

Vistar IRD

• Automatic (No need to use the Manual Search)

1Press MENU

2Select SYSTEM CONFIGURATION, press OK

3Enter PASSWORD, (Default is 1234)

4Select FACTORY DEFAULT, press OK

5Enter PASSWORD (Default is 1234) "Do you want to reset to receiver?", "The access code reset to default?"

6Press OK (Wait for about 5 to 10 seconds)

7Will display WELCOME: press OK to continue

8Will display the LNB CONFIGURATION: check specifications as follows:

9Press OK

10Will display ADD CHANNELS, check specifications as follows: (Signal Strength about 50%, Signal Quality above 75%)

11Press OK (SEARCH CHANNEL) "Searching in progress, please wait..."

12Will display (52) Digital TV Channels; (11) Radio Channels

13Press OK to complete the procedure

Nokia IRD Box

• Manual Search

1On your remote control, select MENU

2Select SETTINGS by pressing the left arrow button

3Press the up arrow button to SYSTEM CONFIGURATION, press OK

4Enter your ACCESS CODE (Default is 1234)

5Under CHANNEL SEARCH, select MANUAL SEARCH

6Set the following configurations:

7Be sure to have signal before pressing OK

8Will display all the channels searched, press OK

9Press BACK to exit the installation

Crystal IRD

• Manual Search

1Press MENU

2Under INSTALLATION, select TP EDIT/SCAN, then press OK

3Edit or set the configuration as follows:

4Press OK

5Will display all the CHANNEL SCANNED

6Exit the installation to view the new channels

Homecast IRD

• Manual Search

1Press MENU, OK

2Go to INSTALLATION then press OK

3Select MANUAL SEARCH

4Enter the ACCESS CODE (Default is 1234)

5Set the configuration as follows:

6Press OK

7Will display "Do you want to save changes?" Select YES

8Exit the installation to view the new channels

DAW IRD (Old Version and Mini)

• Manual Search

1Press MENU

2Go to INSTALLATION, select CHANNEL SEARCH then press OK

3Enter ACCESS CODE (Default is 1234)

4Under EQUIPMENT select NONE, press OK

5CHANNEL SEARCH, select MANUAL (Green button)

6Select ADD TP to set configurations

7Will display the ADD TP, then set the TP# specifications as follows:

8Select the new TP# press SUB.T button, press OK

9Confirmation "SAVED" will appear, press OK

10Exit the installation to view the new channels